Dimplex King Pillow Top Fitted Electric Blanket

Be The First To Review This Product!

Help other KG Electronic Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review

Fitted Electric Blanket
  • Fully fitted non-woven polyester electric blanket
  • Machine washable
  • Detachable controls
  • 12 hour timer
  • Double overheat protection with Sensorsafe technology
  • 2 year warranty
  • 230-240Vac 50Hz
  • Australia Power Plug
  • Dimensions (WxDxH) 1800mm (W) x 2030mm (H)

(DHEBPTK)

This item comes with 2 year Warranty

Auto Off

This controller is fitted with a 12 hour Count Down Auto Off Timer which starts to countdown from when your heat setting has been selected, and will switch power off to the elements after approximately 12 hours. (+/- 30Minutes).
Note: Once a heat setting has been selected and the switch is powered ON, the countdown timer will not be affected by adjusting heat level.
The timer will only be reset to 12 hours by sliding the control knob to heat level “O” or after being powered OFF and then back On.
When the controller has timed out, the element will turn off and the Red LED’s on the front display will flash.
Slide the control knob to the “O” position to reset.

Pre Heat

The controller has a pre-heat facility in order for you to warm your bed prior to getting into it.
The time taken to pre-heat the bed will depend on the ambient temperature of the bedroom and whether an electric blanket has been used to air the bed on a regular basis.
At normal ambient temperature you should allow approximately 30 - 60 minutes on Heat Setting “3” (Pre Heat).
You may get into bed sooner while the bed is still warming up, but please DO NOT leave the blanket set on the Preheat setting (No. 3) while you are in the bed.
A cold room or bed that has not been used for some time may require a greater length of time on the pre-heat.

Overheat / Element Protection

The blanket is fitted with numerous overheat safeguard systems. This offers protection against overheating or damage to the elements by disengaging the power to the elements before overheating hazards occur.
Should there ever be a problem with the heating element in the Blanket, it will automatically close down the operation and the Blanket will turn off.
The controller must not be covered. The controller has built in protection, so that if the controller overheats, or the heating element is damaged, it will automatically close down the operation Permanently.

SKU DHEBPTK
Model # DHEBPTK
Barcode # 9420033208494
Brand DIMPLEX
Shipping Weight 4.8200kg
Shipping Width 0.450m
Shipping Height 0.510m
Shipping Length 0.050m
Shipping Cubic 0.011475m3